BMW · one cylinder head
BMW head gasket repair cost
EstimateData reviewed November 2026How we calculate
Disclosure: this site is supported by advertising and affiliate links. We may earn a commission if you buy through a link, at no cost to you. It never changes our estimates. Read our affiliate disclosure.
- BMW estimate
- $2,030-$4,160
- Independent shop, national rate
- Average vehicle
- $1,270-$2,600
- Same repair, ×1.00
- Vehicle factor
- ×1.60
- European luxury
- Labor
- 8-15 hr
- Typical billed hours
Head Gasket Repair, National average, BMW: estimated $2,030 to $4,160.
Estimated total · National average
Estimate$2,030to$4,160
Against the national average
This is the national figure. Pick your state and the needle shows how local labor rates move it.
Where the money goes
83% labor
- Parts
- $240-$800
- Labor
- $1,790-$3,360
How this number is built
( parts $150-$500 + 8-15 hr × $140/hr ) × 1.60 vehicle factor
Show the math
How we get this number
- Parts
- $150-$500
- Editorial range, aftermarket to OEM
- Labor hours
- 8-15 hr
- Typical: about 10 hr
- Labor rate
- $140/hr
- National baseline, independent shop
- Vehicle factor
- ×1.60
- BMW: european luxury
( $150-$500 + 8-15 hr × $140 ) × 1.60
= $2,030 to $4,160
Low end = lowest parts + fewest hours. High end = highest parts + most hours. Each part rounded to the nearest $5.
About the ×1.60 factor: Premium parts pricing, tighter packaging and brand-specific tooling. It is a class-level editorial assumption, not a figure measured for the BMW. Methodology.
What is different about the BMW
Inline-six versus V8
BMW’s inline four- and six-cylinder engines have a single cylinder head. V8 models have two, and access to the rear of the engine is tight; expect those quotes to exceed the top of this range.
Overheating does extra damage on aluminium engines
BMW engines use aluminium heads (and often aluminium blocks) that warp readily when overheated. Machine-shop inspection and resurfacing should be assumed, and a cracked head changes the job from a gasket to a cylinder head replacement.
Single-use fasteners and timing tools
The head bolts are stretch-type and are replaced, and resetting cam timing on BMW engines needs engine-specific locking tools. That is why an independent BMW specialist is usually a better choice than a general shop, and usually cheaper than the dealer.
Run the repair-or-replace numbers
On an older BMW, a head gasket quote can approach or exceed the car’s market value. That alone is not a reason to scrap it, but it is exactly the situation our repair-or-replace calculator is built for.
BMW head gasket repair cost by state
| State | Labor $/hr | Independent | Dealer |
|---|---|---|---|
| National average | $2,030-$4,160 | $2,480-$5,000 | |
| Alabama | $1,840-$3,800 | $2,225-$4,520 | |
| Alaska | $2,030-$4,160 | $2,480-$5,000 | |
| Arizona | $2,030-$4,160 | $2,480-$5,000 | |
| Arkansas | $1,775-$3,680 | $2,160-$4,400 | |
| California | $2,290-$4,640 | $2,800-$5,600 | |
| Colorado | $2,030-$4,160 | $2,480-$5,000 | |
| Connecticut | $2,095-$4,280 | $2,545-$5,120 | |
| Delaware | $2,030-$4,160 | $2,480-$5,000 | |
| District of Columbia | $2,225-$4,520 | $2,735-$5,480 | |
| Florida | $2,095-$4,280 | $2,545-$5,120 | |
| Georgia | $1,970-$4,040 | $2,415-$4,880 | |
| Hawaii | $2,160-$4,400 | $2,670-$5,360 | |
| Idaho | $1,905-$3,920 | $2,350-$4,760 | |
| Illinois | $2,030-$4,160 | $2,480-$5,000 | |
| Indiana | $1,905-$3,920 | $2,350-$4,760 | |
| Iowa | $1,840-$3,800 | $2,225-$4,520 | |
| Kansas | $1,840-$3,800 | $2,225-$4,520 | |
| Kentucky | $1,840-$3,800 | $2,225-$4,520 | |
| Louisiana | $1,840-$3,800 | $2,225-$4,520 | |
| Maine | $1,970-$4,040 | $2,415-$4,880 | |
| Maryland | $2,095-$4,280 | $2,545-$5,120 | |
| Massachusetts | $2,160-$4,400 | $2,670-$5,360 | |
| Michigan | $1,905-$3,920 | $2,350-$4,760 | |
| Minnesota | $2,030-$4,160 | $2,480-$5,000 | |
| Mississippi | $1,775-$3,680 | $2,160-$4,400 | |
| Missouri | $1,905-$3,920 | $2,350-$4,760 | |
| Montana | $1,840-$3,800 | $2,225-$4,520 | |
| Nebraska | $1,840-$3,800 | $2,225-$4,520 | |
| Nevada | $1,970-$4,040 | $2,415-$4,880 | |
| New Hampshire | $2,095-$4,280 | $2,545-$5,120 | |
| New Jersey | $2,160-$4,400 | $2,670-$5,360 | |
| New Mexico | $1,840-$3,800 | $2,225-$4,520 | |
| New York | $2,160-$4,400 | $2,670-$5,360 | |
| North Carolina | $1,905-$3,920 | $2,350-$4,760 | |
| North Dakota | $1,840-$3,800 | $2,225-$4,520 | |
| Ohio | $1,905-$3,920 | $2,350-$4,760 | |
| Oklahoma | $1,840-$3,800 | $2,225-$4,520 | |
| Oregon | $2,095-$4,280 | $2,545-$5,120 | |
| Pennsylvania | $1,970-$4,040 | $2,415-$4,880 | |
| Rhode Island | $2,030-$4,160 | $2,480-$5,000 | |
| South Carolina | $1,905-$3,920 | $2,350-$4,760 | |
| South Dakota | $1,840-$3,800 | $2,225-$4,520 | |
| Tennessee | $1,905-$3,920 | $2,350-$4,760 | |
| Texas | $1,970-$4,040 | $2,415-$4,880 | |
| Utah | $1,970-$4,040 | $2,415-$4,880 | |
| Vermont | $1,970-$4,040 | $2,415-$4,880 | |
| Virginia | $2,030-$4,160 | $2,480-$5,000 | |
| Washington | $2,160-$4,400 | $2,670-$5,360 | |
| West Virginia | $1,840-$3,800 | $2,225-$4,520 | |
| Wisconsin | $1,905-$3,920 | $2,350-$4,760 | |
| Wyoming | $1,840-$3,800 | $2,225-$4,520 |
Signs your BMW needs head gasket repair
- Engine overheating
- White, sweet-smelling exhaust smoke
- Coolant loss with no visible leak
- Milky, light-brown oil on the dipstick or filler cap
- Bubbles in the coolant reservoir or radiator
Before you approve the quote
FAQ
BMW head gasket repair: FAQ
How much does head gasket repair cost on a BMW?
We estimate $2,030-$4,160 at an independent shop and $2,480-$5,000 at a dealer, using national average labor rates and a vehicle factor of ×1.60. Your state and shop will move the figure; use the calculator on this page.
Is head gasket repair more expensive on a BMW than on other cars?
Yes, in our model. We apply a ×1.60 factor to the BMW for this repair, compared with ×1.00 for a mainstream car. The factor is an editorial adjustment, not a measured statistic.
Is it worth fixing a head gasket on a BMW?
It depends on the car’s value, its overall condition and whether the head survived the overheating. If the quote exceeds the car’s private-party value and other major work is due, replacing the car is often the better financial choice. Use the repair-or-replace calculator with your own numbers.
How long does head gasket repair take on a BMW?
Typically two to four days, depending on machine-shop turnaround. Shops typically bill 8-15 labor hours.